Service Calls – $365

Our service call rate covers general small electrical requests and includes 1 hour of labor (materials not included). This is ideal for minor electrical issues such as non-functioning outlets, replacing a few light fixtures, or swapping out an electrical outlet.

Covers Multnomah, Washington, Clackamas, and Clark Counties.
Additional $100 travel fee applies for locations beyond these areas.
This rate applies to time and material work. If a customer prefers hourly work over a flat-rate bid, this pricing structure applies.
Materials are billed separately at cost.

Hourly Rates

Journeyman Electrician: $185 per hour
Apprentice Electrician: $95 per hour
Trip Fee: $100 minimum per visit
Materials: Billed separately at cost.

EV Charger Installation – $650 + Cost of Materials

Includes the installation of a 50-amp circuit for a hardwired EV charger.

The electrical panel must have available space for a 2-pole breaker and enough capacity for an additional 50-amp load.
Charger must be installed within 10 feet horizontally of the panel. If further, a separate bid is required.
Charger not included; installation only.
A $100 additional trip fee applies if outside our primary service area.
Materials are billed separately at cost.

EV Charging Plug Installation – $850 + Cost of Materials

Includes the installation of a 50-amp circuit, an EV-rated NEMA 14-50 receptacle, and a GFCI 50-amp breaker (required by code).

Installation must be within 10 feet of the electrical panel.
The same service area and trip fee conditions as above apply.
Materials are billed separately at cost.

Panel Replacement – $2,750 + Cost of Materials

Replacement of an existing panel with a new Eaton BR panel of the same ampacity. Includes:

All new breakers and an updated bonding system (including two ground rods).
Permit fees included.
If the panel is located in a finished wall, drywall may need to be removed above and below the panel. Drywall repair is not included.
Materials are billed separately at cost.

Electrical Service Upgrade to 200 Amps – $5,950 + Cost of Materials

Upgrading an existing service to 200 amps, including:

New Eaton meter main base with a 2-inch rigid mast.
Running new 200-amp rated SER cable from the meter to the panel.
Coordination with the utility provider for meter spot approval and switchover.
Pricing applies if the panel is within 25 feet of the meter base. If further, additional costs apply ($300–$1,000, depending on distance and accessibility).
Materials are billed separately at cost.

For any projects beyond these scopes, we are happy to provide a custom estimate. Contact us today to schedule a consultation!